Suzuki SFV650 - Repair Instructions; Engine Oil and Filter Replacement; Engine Oil Level Inspection; Oil Strainer; Oil Pressure Regulator Removal and Installation

Engine Lubrication System: 1E-6
7) Reinstall the main oil gallery plug (1) and tighten it to
the specified torque.
CAUTION
!
Use a new gasket to oil leakage.
Tightening torque
Main Oil gallery plug (M12) (a): 21 N·m (2.1 kgf-
m, 15.0 lbf-ft)
8) Check the engine oil level. Refer to “Engine Oil and
Filter Replacement in Section 0B (Page 0B-10)”.
Repair Instructions
Engine Oil and Filter Replacement
B944H11506001
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-10)”.
Engine Oil Level Inspection
B944H11506002
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-10)”.
Oil Strainer / Oil Pressure Regulator Removal
and Installation
B944H11506003
Removal
1) Remove the engine assembly from the frame. Refer
to “Engine Assembly Removal in Section 1D
(Page 1D-18)”.
2) Disassemble the engine top side. Refer to “Engine
Top Side Disassembly in Section 1D (Page 1D-25)”.
3) Separate the left and right crankcase. Refer to
“Engine Bottom Side Disassembly in Section 1D
(Page 1D-58)”.
4) Remove the oil pressure regulator (1).
5) Remove the oil strainer plate (2).
6) Remove the oil strainer (3).
Installation
Installation is in the reverse order of removal.
Pay attention to the following points:
• Install the oil strainer (1).
CAUTION
!
• The lip “A” of the oil strainer should be
positioned downward.
• The shorter side “B” of the oil strainer
should be positioned inside.
(a)
1
I944H1150046-01
1
I944H1150004-01
2
3
I944H1150005-02
1
“B”
I944H1140068-01