Suzuki SFV650 - Tightening Torque Specifications; Special Tools and Equipment; Recommended Service Material; Special Tool

5C-17 Clutch:
Tightening Torque Specifications
B944H15307002
NOTE
The specified tightening torque is described in the following.
“Clutch Lever Components (Page 5C-3)”
“Clutch Components (Page 5C-6)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
Special Tools and Equipment
Recommended Service Material
B944H15308001
NOTE
Required service material is also described in the following.
“Clutch Lever Components (Page 5C-3)”
“Clutch Components (Page 5C-6)”
Special Tool
B944H15308002
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Clutch sleeve hub nut 50 5.0 36.0 )(Page 5C-10)
Clutch spring set bolt 10 1.0 7.0 )(Page 5C-11)
Primary drive gear bolt 70 7.0 50.5 )(Page 5C-15)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 5C-5) / )(Page 5C-
5)
SUZUKI SILICONE GREASE or
equivalent
P/No.: 99000–25100 )(Page 5C-4)
09900–06107 09900–20102
Snap ring remover (Open
type)
Vernier calipers (200 mm)
)(Page 5C-9) / )(Page 5C-
9) / )(Page 5C-15) /
)(Page 5C-16)
)(Page 5C-13) /
)(Page 5C-13) /
)(Page 5C-13)
09900–20803 09900–25008
Thickness gauge Multi circuit tester set
)(Page 5C-13) )(Page 5C-2)
09920–53740 09930–40113
Clutch sleeve hub holder Flywheel rotor holder
)(Page 5C-8) / )(Page 5C-
10)
)(Page 5C-14) /
)(Page 5C-15)