Engine Cooling System: 1F-7
Water Hose Inspection
B944H11606005
Inspect the water hose in the following procedures:
1) Remove the frame body covers, left and right. Refer
to “Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
2) Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
radiator hose with a new one.
3) Any leakage from the connecting section should be
corrected by proper tightening. Refer to “Water Hose
Routing Diagram (Page 1F-3)”.
4) After finishing the water hose inspection, reinstall the
removed parts.
Water Hose Removal and Installation
B944H11606006
Removal
1) Drain engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-12)”.
2) Remove the frame body covers, left and right. Refer
to “Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
3) Remove the water hose as shown in the water hose
routing diagram. Refer to “Water Hose Routing
Diagram (Page 1F-3)”.
Installation
1) Install the water hose as shown in the water hose
routing diagram. Refer to “Water Hose Routing
Diagram (Page 1F-3)”.
2) Pour engine coolant and bleed air from the cooling
circuit. Refer to “Cooling System Inspection in
Section 0B (Page 0B-12)”.
3) Reinstall the removed parts.
Radiator Reservoir Tank Inspection
B944H11606007
Inspect the radiator reservoir tank in the following
procedures:
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
2) Remove the left frame cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
4)”.
3) Inspect the radiator reservoir tank coolant leaks. If
any defects are found, replace the radiator reservoir
tank with a new one.
4) Reinstall the removed parts.
I944H1160012-01
I944H1160013-01
I944H1160014-01
I944H1160050-02
To Next Page
Loading...
