Combination Meter / Fuel Meter / Horn: 9C-5
Fuel Level Indicator Light Inspection
B944H19306008
If the fuel level indicator light (1) does not function
properly, check the fuel level gauge and its lead wire/
coupler. Refer to “Fuel Level Gauge Inspection
(Page 9C-5)”.
If the fuel level gauge and its lead wire/coupler are
functioning properly, replace the combination meter with
a new one. Refer to “Combination Meter Removal and
Installation (Page 9C-2)”.
Fuel Level Gauge Inspection
B944H19306009
Inspect the fuel level gauge in the following procedures:
1) Remove the fuel pump assembly. Refer to “Fuel
Pump Disassembly and Assembly in Section 1G
(Page 1G-10)”.
2) Measure the resistance at each fuel level gauge float
position. If the resistance is incorrect, replace fuel
level gauge with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
3) Install the fuel pump assembly. Refer to “Fuel Pump
Disassembly and Assembly in Section 1G (Page 1G-
10)”.
Speedometer Inspection
B944H19306010
If the speedometer, odometer or tripmeter does not
function properly, inspect the speed sensor and the
coupler connections. If the speed sensor and coupler
connections are OK, replace the combination meter unit
with a new one. Refer to “Combination Meter Removal
and Installation (Page 9C-2)”.
Speed Sensor Removal and Installation
B944H19306011
Removal
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
2) Remove the engine sprocket cover (1). Refer to
“Engine Sprocket Removal and Installation in
Section 3A (Page 3A-2)”.
3) Disconnect the speed sensor coupler (2).
4) Disconnect the speed sensor lead wire from the
clamps (3).
5) Remove the speed sensor (4).
Float position Resistance
Full “a” 10 – 20 Ω
Empty “b” 84 – 90 Ω
“A”: Horizontal
FI
1
I944H1930012-01
“A”
2q
50q
147.3 mm
(5.80 in)
49.8 mm
(1.96 in)
“b”
“a”
I944H1930013-01
1
I944H11A0004-01
2
I944H1930015-01
4
3
I944H1930016-02
To Next Page
Loading...
