1H-9 Ignition System:
3) Measure the resistance between the lead wires and
ground. If the resistance is not within the standard
range, replace the CKP sensor with a new one.
Refer to “CKP Sensor Removal and Installation
(Page 1H-9)”.
Tester knob indication
Resistance (Ω)
CKP sensor resistance
160 – 240 Ω (B/R – B/Y)
∞ Ω (B/R – Ground)
4) After measuring the CKP sensor resistance, connect
the CKP sensor coupler (1).
CKP Sensor Removal and Installation
B944H11806005
Refer to “Generator Removal and Installation in Section
1J (Page 1J-4)”.
Engine Stop Switch Inspection
B944H11806006
Inspect the engine stop switch in the following
procedures:
1) Remove the right frame body cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
2) Disconnect the right handlebar switch coupler (1).
3) Inspect the engine stop switch for continuity with a
tester.
If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the engine stop switch inspection,
reinstall the removed parts.
Ignition Switch Inspection
B944H11806007
Refer to “Ignition Switch Inspection in Section 9C
(Page 9C-7)”.
Ignition Switch Removal and Installation
B944H11806008
Removal
1) Remove the right frame body cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
2) Disconnect the ignition switch coupler (1) and clamp
(2).
2. CKP sensor coupler 3. CKP sensor
3
2
I718H1180008-02
1
I944H1180017-01
B/Bl B/R
Color
Position
OFF
RUN
()
()
I944H1180018-01
1
2
I944H1180019-02
To Next Page
Loading...
