Suzuki SFV650 - Regulator; Rectifier Removal and Installation

Charging System: 1J-9
3) Measure the voltage between the terminals using the multi-circuit tester as indicated in the following table. If the
voltage is not within the specified value, replace the regulator/rectifier with a new one.
NOTE
If the tester reads 1.4 V and below when the tester probes are not connected, replace its battery.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
Unit: V
4) Connect the regulator/rectifier couplers (1).
Regulator / Rectifier Removal and Installation
B944H11A06011
Removal
1) Remove the right frame body cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
2) Disconnect the regulator/rectifier couplers (1) and
clamp (2).
3) Remove the regulator/rectifier (3) by removing the
regulator/rectifier bolt (4).
Installation
1) Install the regulator/rectifier as shown in the
regulator/rectifier construction. Refer to “Regulator /
Rectifier Construction (Page 1J-8)”.
2) Install the right frame body cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)”.
B1
B2
B3
B/R2
B/R1
B/W1
B/W2
I944H11A0022-02
(+) probe of tester to:
B/R
1
B/R
2
B
1
B
2
B
3
B/W
1
B/W
2
(–) probe of
tester to:
B/R
1
— 0 0.1 – 0.8 0.1 – 0.8 0.1 – 0.8 0.3 – 1.0 0.3 – 1.0
B/R
2
0 — 0.1 – 0.8 0.1 – 0.8 0.1 – 0.8 0.3 – 1.0 0.3 – 1.0
B
1
* * — * * 0.1 – 0.8 0.1 – 0.8
B
2
* * * — * 0.1 – 0.8 0.1 – 0.8
B
3
* * * * — 0.1 – 0.8 0.1 – 0.8
B/W
1
*****—0
B/W
2
*****0—
*1.4 V and more (tester’s battery voltage)
1
2
I944H11A0023-02
3
3
4
4
I944H11A0024-02