Suzuki SFV650 - Clutch Installation

5C-9 Clutch:
15) Remove the spacer (21).
16) Remove the snap ring (22), oil pump drive gear (23)
and pin (24).
Special tool
: 09900–06107 (Snap ring pliers)
Clutch Installation
B944H15306020
1) Install the pin (1).
2) When installing the oil pump drive gear (2), align the
pin (1) with the slot “A” with the flange side “B” of the
oil pump drive gear facing the primary drive gear.
3) Install the snap ring (3).
CAUTION
!
The removed snap ring (3) must be replaced
with a new one.
Special tool
: 09900–06107 (Snap ring pliers)
4) Install the spacer (4) and apply engine oil to it.
5) Install the primary driven gear assembly (5) onto the
countershaft.
NOTE
When installing the primary driven gear
assembly (5), align the teeth of the primary
drive gears (6) by inserting a suitable bar to
the holes of them.
Be sure to engage the oil pump driven (7) and
oil pump drive gears (2), primary drive (6) and
driven gears (8).
21
I944H1530029-02
24
22
23
I944H1530030-02
2
“A”
“B”
1
I944H1530031-02
3
I944H1530032-01
4
I944H1530033-01
5
6
7
2
8
I944H1530034-02