1D-83 Engine Mechanical:
Crankshaft Journal Bearing Inspection and
Selection
B944H11406029
Refer to “Engine Bottom Side Disassembly (Page 1D-
58)”.
Refer to “Engine Bottom Side Assembly (Page 1D-65)”.
Inspection
1) Inspect each upper and lower crankcase bearings
(1) for any damage.
2) Inspect the crankshaft journal for any damage.
3) Measure the crankshaft O.D. with the special tool. If
any of the measurements are out of specification,
replace the crankshaft.
Special tool
(A): 09900–20202 (Micrometer (1/100 mm,
25 – 50 mm))
Crankshaft journal O.D.
Standard: 41.985 – 42.000 mm (1.6529 – 1.6535
in)
Selection
1) Select the specified bearings from the crankcase
journal I.D. codes. The crankcase journal I.D. codes
((A), (B) or (C)) “A”, is stamped on the inside of each
crankcase half.
CAUTION
!
The bearings should be replaced as a set.
Crankcase journal I.D. specification
Bearing thickness specification
1
1
I944H1140127-01
I944H1140128-01
(A)
I944H1140129-01
Code “A” I.D. specification Bearing color
A
46.000 – 46.006 mm
(1.8110 – 1.8113 in)
Green
B
46.006 – 46.012 mm
(1.8113 – 1.8115 in)
Black
C
46.012 – 46.018 mm
(1.8115 – 1.8117 in)
Brown
Color “B” (Part No.) Thickness
Green
1.999 – 2.002 mm
(0.0787 – 0.0788 in)
Black
2.002 – 2.005 mm
(0.0788 – 0.0789 in)
Brown
2.005 – 2.008 mm
(0.0789 – 0.0791 in)
B
“A”
I944H1140131-01
B
“A”
I944H1140132-01
To Next Page
Loading...
