Suzuki SFV650 - Clutch Push Rod (Left) Inspection

5C-5 Clutch:
4) Pull out the oil seal (3), bearing (4) with the clutch
release camshaft (5).
5) Remove the bearing (6) and oil seal (7).
Installation
Install the clutch push rod (left) / clutch release camshaft
in the reverse order of removal. Pay attention to the
following points:
CAUTION
!
The removed bearings and oil seals must be
replaced with new ones.
• Apply grease to the bearings, oil seals, release
camshaft and clutch push rod cap.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
NOTE
The stamped mark side of the bearing face
upside.
• Apply a small quantity of grease to the clutch push
rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
Clutch Push Rod (Left) Inspection
B944H15306019
Inspect the push rod in the following procedures:
1) Remove the clutch push rod. Refer to “Clutch Push
Rod (Left) / Clutch Release Camshaft Removal and
Installation (Page 5C-4)”.
2) Inspect the push rod for wear or bend. If any defects
are found, replace it with a new one.
3) Reinstall the removed parts. Refer to “Clutch Push
Rod (Left) / Clutch Release Camshaft Removal and
Installation (Page 5C-4)”.
3
5
4
2
3
5
4
I944H1530011-01
7
6
I944H1530012-01
I944H1530013-01
I944H1530014-01
I944H1530015-01
I944H1530016-01