Lighting Systems: 9B-5
4) Reinstall the removed parts.
NOTE
Properly fit the bulb socket rubber cap (1).
5) After installing be sure to inspect the headlight
beam. Refer to “Headlight Beam Adjustment
(Page 9B-5)”.
Position Light Bulb
Replace the position light bulb in the following
procedures:
1) Remove the headlight assembly. Refer to “Headlight
Removal and Installation (Page 9B-4)”.
2) Remove the position light socket (1).
3) Replace the position light bulb (2).
4) Reinstall the removed parts.
Headlight Beam Adjustment
B944H19206005
Adjust the headlight beam in the following procedures:
Insert a plus screw driver along the guide as shown and
adjust the headlight beam horizontally.
NOTE
Adjust the beam horizontally first, then
vertically.
1
I944H1920009-01
2
I944H1920010-01
“A”: Horizontal adjuster
“B”: Vertical adjuster
“A”
I944H1920011-01
“B”
I944H1920012-01
To Next Page
Loading...
