1F-8 Engine Cooling System:
Radiator Reservoir Tank Removal and
Installation
B944H11606008
Removal
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
2) Remove the left frame cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
4)”.
3) Disconnect the reservoir tank inlet hose (1) and drain
the engine coolant.
4) Disconnect the reservoir tank overflow hose (2) and
spark plug cap (3).
5) Remove the reservoir tank mounting (4) by removing
the reservoir tank mounting bolt (5).
Installation
1) Install the reservoir tank (1) as shown in the water
hose routing diagram. Refer to “Water Hose Routing
Diagram (Page 1F-3)”.
2) Fill the reservoir tank to the upper level “A”.
3) Reinstall the removed parts.
Cooling Fan Inspection
B944H11606009
Cooling fan operating temperature
Standard
(ON→OFF): Approx. 92 °C (198 °F)
(OFF→ON): Approx. 98 °C (208 °F)
Inspect the cooling fan in the following procedures:
1) Remove the right frame body cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-4)”.
2) Disconnect the cooling fan motor coupler (1).
3) Test the cooling fan motor for load current with an
ammeter connected as shown in the figure.
If the fan motor does not turn, replace the cooling fan
motor with a new one. Refer to “Radiator / Cooling
Fan Motor Removal and Installation (Page 1F-5)”.
1
I944H1160051-02
2
3
I944H1160052-02
4
5
I944H1160053-02
1
“A”
F
I944H1160054-02
1
I944H1160015-01
To Next Page
Loading...
