Suzuki SFV650 - Gear Position Switch Inspection; Gear Position Switch Removal and Installation

5B-12 Manual Transmission:
3) Install the oil seals (2) using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
4) Apply grease to the oil seal lips.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the transmission assembly. Refer to
“Transmission Removal and Installation (Page 5B-
3)”.
Gear Position Switch Inspection
B944H15206007
Refer to “Side-stand / Ignition Interlock System Parts
Inspection in Section 1I (Page 1I-8)”.
Gear Position Switch Removal and Installation
B944H15206008
Refer to “Electrical Components Location in Section 0A
(Page 0A-7)”.
Refer to “Wiring Harness Routing Diagram in Section 9A
(Page 9A-5)”.
Removal
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
3) Disconnect the gear position switch coupler (1).
4) Remove the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
5) Remove the oil seal retainer mounting bolts (2).
6) Remove the gear position switch mounting bolts (3).
7) Move the oil seal retainer (4) as shown.
8) Remove the gear position switch.
(A)
2
I944H1520042-01
2
2
(A)
(A)
I944H1520043-01
I944H1520044-01
1
I944H1520068-01
2
2
3
I944H1520028-02
4
I944H1520029-02