Engine Mechanical: 1D-2
Throttle Cable Routing Diagram
B944H11402002
3
7
1
2
“b”
2
“b”
“a”
4
“D”
“E”
“F”
3
6
5
“A”
“C”
1
“B”
I944H1140330-02
1. Throttle cable No. 1 “B”: The adjustment of clutch cable play should be made on the adjuster on
which the clutch cable cap is installed with 3-5 mm of threads left on
the clutch lever adjuster.
2. Throttle cable No. 2 “C”: Pass the clutch cable inside of the clutch cable guide and behind the
headlight housing brace.
3. Clutch cable “D”: Pass the clutch cable over the wiring harness.
4. Frame head pipe tape “E”: Pass the clutch cable left side of frame head pipe.
Pass the throttle cables right side of frame head pipe.
5. Clamp
: Bind the clutch cable to frame bridge with the clamp. Set the locked
part facing outside.
“F”: Pass the clutch cable under the radiator inlet hose.
6. Clutch cable stopper “a”: 15 – 20 mm (0.6 – 0.8 in)
7. Headlight housing brace “b”: 0 – 1 mm (0 – 0.04 in)
“A”: Pass the throttle cables inside of the throttle cable guide and behind the
headlight housing brace.
To Next Page
Loading...
