Clutch: 5C-16
Reassembly
1) Set the springs (1) into the grooves.
2) Install the scissors gear (2).
NOTE
Align the hole of the primary drive gear with
the hole of the scissors gear.
3) Install the spring washer (3) not to cover the holes of
the gears.
NOTE
The convex side of the spring washer (3)
faces upward.
4) Install the new snap ring (4).
Special tool
: 09900–06107 (Snap ring pliers)
CAUTION
!
The removed snap ring (4) must be replaced
with a new one.
After installing a snap ring, always insure
that it is completely seated in its groove and
securely fitted.
Specifications
Service Data
B944H15307001
Clutch
Unit: mm (in)
1
1
1
1
2
I944H1530062-01
3
I944H1530063-01
4
I944H1530064-01
Item Standard Limit
Clutch cable play 10 – 15 (0.4 – 0.6) —
Clutch release screw 1 turn back —
Clutch drive plate thickness No. 1, 2 2.92 – 3.08 (0.115 – 0.121) 2.62 (0.103)
Clutch drive plate claw width No. 1, 2 13.7 – 13.8 (0.539 – 0.543) 12.9 (0.508)
Clutch driven plate distortion — 0.10 (0.004)
Clutch spring free length 53.1 (2.09) 50.4 (1.98)
To Next Page
Loading...
