1A-97 Engine General Information and Diagnosis:
DTC “C42” (P1650): IG Switch Circuit Malfunction
B944H11104025
Detected Condition and Possible Cause
Troubleshooting
NOTE
• Refer to “Ignition Switch Inspection in Section 1H (Page 1H-9)” for details.
• After repairing the trouble, clear the DTC using SDS tool. Refer to “Use of SDS Diagnosis Reset
Procedures (Page 1A-15)”.
DTC “C44” (P0130 / P0135): HO2 Sensor (HO2S) Circuit Malfunction
B944H11104026
Detected Condition and Possible Cause
Wiring Diagram
ECM coupler (Harness side)
Detected Condition Possible Cause
Ignition switch signal is not input to the ECM. • Ignition system circuit open or short.
• ECM malfunction.
Detected Condition Possible Cause
C44/P0130
After engine is started few minutes.
(Sensor voltage ≥ 2.5 V)
Engine is cold and stopped.
(Sensor output voltage < 0.1 V)
In other than the above value, C44
(P0130) is indicated.
• HO2 sensor circuit open or shorted to ground.
• Fuel system malfunction.
• ECM malfunction.
C44/P0135
The heater can not operate so that heater
operation voltage is not supply to the
oxygen heater circuit.
• Battery voltage supply to the HO2 sensor.
ECM
Side-stand
relay
Ignition
switch
Engine stop
switch
O/W
W
Gr
B
W
B/Br
W/G
W/B
HO2 sensor
HO2S
HO2. H
E2
To GP
switch
6
12
17
I944H1110083-01
1234567891011121314151617
18
18 19 20 21 22 23 26 2724 25 28 29 30 31 32 33 34
35
36
37 38 39 40 41 42 43
44 45 46 47 48 49 50 51 52
I944H1110084-01
To Next Page
Loading...
