Suzuki SFV650 - Specifications; Service Data; Tightening Torque Specifications

Ignition System: 1H-10
3) Remove the ignition switch mounting bolts (3) with
the special tools and remove the ignition switch (4).
Special tool
: 09930–11920 (Torx bit (JT40H))
: 09930–11940 (Bit holder)
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following point:
• Apply thread lock to the ignition switch mounting bolts
(1).
CAUTION
!
When reusing the ignition switch mounting
bolts, clean threaded part and apply the
thread lock to them.
Special tool
: 09930–11920 (Torx bit (JT40H))
: 09930–11940 (Bit holder)
: Thread lock cement 99000–32110 (THREAD
LOCK CEMENT SUPER 1322 or equivalent)
Specifications
Service Data
B944H11807001
Electrical
Unit: mm (in)
Tightening Torque Specifications
B944H11807002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
4
3
I944H1180020-02
1
I944H1180021-02
Item Specification Note
Spark plug
Type
NGK: CR8EIA-9
DENSO: IU24D
Gap
0.8 – 0.9
(0.031 – 0.035)
Spark performance Over 8 (0.3) at 1 atm.
CKP sensor resistance 160 – 240 Ω
CKP sensor peak voltage 4.6 V and more When cranking
Ignition coil resistance
Primary 1 – 3 Ω Terminal – Terminal
Secondary 25 – 40 Ω Plug cap – Plug cap
Ignition coil primary peak voltage 150 V and more When cranking
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Spark plug 11 1.1 8.0 )(Page 1H-5)