1J-8 Charging System:
• Tighten the clutch release arm bolt (11) to the
specified torque.
Tightening torque
Clutch release arm bolt (e): 9 N·m (0.9 kgf-m, 6.5
lbf-ft)
• Check the clutch cable play. Refer to “Clutch System
Inspection in Section 0B (Page 0B-14)”.
• After installing the removed parts, pour engine oil.
Refer to “Engine Oil and Filter Replacement in
Section 0B (Page 0B-10)”.
Regulator / Rectifier Construction
B944H11A06012
Regulator / Rectifier Inspection
B944H11A06006
Inspect the regulator/rectifier in the following procedures:
1) Turn the ignition switch OFF.
2) Disconnect the regulator/rectifier couplers (1).
“C”
“D”
(e)
11
I944H11A0020-03
2
3
1
“A”
“a”
I944H11A0027-01
1. Regulator/rectifier 3. Ignition coil #2 “a”: 30°
2. Ignition coil #1 “A”: Set the regulator/rectifier couplers in the inside of the frame
1
I944H11A0021-01