Suzuki SFV650 - Specifications; Service Data; Tightening Torque Specifications

Starting System: 1I-13
3) Inspect the starter button for continuity with a tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the starter button inspection, reinstall
the right frame body cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
4)”.
Specifications
Service Data
B944H11907001
Electrical
Unit: mm (in)
Tightening Torque Specifications
B944H11907002
NOTE
The specified tightening torque is described in the following.
“Starter Motor Components (Page 1I-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
B/R Bl/B B/O G/B
I944H1190039-01
Item Specification Note
Starter motor brush length
Standard 10 (0.39)
Limit 6.5 (0.26)
Starter relay resistance 3 – 6 Ω
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Starter motor mounting bolt 10 1.0 7.0 )(Page 1I-4)
Starter motor lead wire mounting nut 6 0.6 4.5 )(Page 1I-4)
Starter motor brush holder mounting nut 7 0.7 5.0 )(Page 1I-5)
Starter motor housing bolt 3.5 0.35 2.5 )(Page 1I-5)
Starter clutch bolt 25 2.5 18.0 )(Page 1I-11)