Suzuki SFV650 - Valve Clearance Inspection and Adjustment

1D-43 Engine Mechanical:
Intake Pipe
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent mixture air from
soaking through the joint.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
NOTE
• Face the “UP” mark “A” on the intake pipe
to upper.
• The intake pipe can be identified by the
marks, “F” and “R”.
Thermostat
Install the thermostat assembly (1) and water hoses (2).
Refer to “Water Hose Routing Diagram in Section 1F
(Page 1F-3)”.
Radiator Hose / Breather Hose
Install the radiator hose (1), oil cooler hoses (2) and
breather hose (3).
Refer to “Water Hose Routing Diagram in Section 1F
(Page 1F-3)” and “Throttle Body Construction (Page 1D-
8)”.
Valve Clearance Inspection and Adjustment
B944H11406008
Refer to “Valve Clearance Inspection and Adjustment in
Section 0B (Page 0B-4)”.
“F”: Front cylinder head intake pipe
“R”: Rear cylinder head intake pipe
“A”
“A”
UP F
UP F
UP R
UP R
I944H1140211-05
I944H1140212-01
1
2
2
I944H1140135-01
1
2
2
3
I944H1140134-01