Suzuki SFV650 - Swingarm Bearing Removal and Installation

Rear Suspension: 2C-10
Swingarm
Inspect the swingarm for damage. If any defect is found,
replace the swingarm with a new one.
Swingarm Pivot Shaft
Measure the swingarm pivot shaft runout using the dial
gauge. If the runout exceeds the service limit, replace
the pivot shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Swingarm pivot shaft runout
Service limit: 0.3 mm (0.01 in)
Swingarm Bearing Removal and Installation
B944H12306013
Removal
1) Remove the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-11)”.
2) Remove the swingarm. Refer to “Swingarm Removal
and Installation (Page 2C-8)”.
3) Draw out the swingarm pivot bearings (1) using the
special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
4) Remove the center spacer (2).
5) Remove the swingarm cushion rod bearings (3)
using the special tools.
Special tool
(A): 09921–20240 (Bearing remover set)
I944H1230038-01
(A)
(B)
(C)
I649G1230034-03
1
(A)
I944H1230039-01
2
I944H1230040-01
(A)
3
I944H1230041-02