Suzuki SFV650 - Oil Strainer Inspection and Cleaning; Oil Pressure Regulator Inspection; Oil Cooler Removal and Installation

1E-7 Engine Lubrication System:
• Tighten the oil pressure regulator (2) to the specified
torque.
Tightening torque
Oil pressure regulator (a): 27 N·m (2.7 kgf-m, 19.5
lbf-ft)
• Assemble the engine. Refer to “Engine Bottom Side
Assembly in Section 1D (Page 1D-65)” and “Engine
Top Side Assembly in Section 1D (Page 1D-31)”.
• Remount the engine assembly. Refer to “Engine
Assembly Installation in Section 1D (Page 1D-22)”.
Oil Strainer Inspection and Cleaning
B944H11506013
Inspect the oil strainer in the following procedures:
1) Remove the oil strainer. Refer to “Oil Strainer / Oil
Pressure Regulator Removal and Installation
(Page 1E-6)”.
2) If the oil strainer is clogged with sediment or rust,
clean the oil strainer using compressed air.
NOTE
When the strainer is dirtied excessively,
replace the oil strainer with a new one.
3) Install the oil strainer. Refer to “Oil Strainer / Oil
Pressure Regulator Removal and Installation
(Page 1E-6)”.
Oil Pressure Regulator Inspection
B944H11506004
1) Remove the oil pressure regulator. Refer to“Oil
Strainer / Oil Pressure Regulator Removal and
Installation (Page 1E-6)”.
2) Inspect the operation of the oil pressure regulator by
pushing on the piston with a proper bar.
3) If the piston does not operate, replace the oil
pressure regulator with a new one.
4) Install the oil pressure regulator. Refer to “Oil
Strainer / Oil Pressure Regulator Removal and
Installation (Page 1E-6)”.
Oil Cooler Removal and Installation
B944H11506005
Removal
1) Drain engine oil and engine coolant. Refer to
“Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)” and “Cooling System Inspection in
Section 0B (Page 0B-12)”.
2) Remove the Oil filter. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)”.
“A” Lip “C” Lower side
“B” Shorter side
“B”
“A”
“C”
I944H1150007-01
(a)
2
I944H1150008-02
I944H1150009-01
I944H1150010-01