Engine Mechanical: 1D-18
Engine Assembly Removal
B944H11406059
Before taking the engine out of the frame, wash the
engine using a stream cleaner. Engine removal is
sequentially explained in the following steps:
1) Drain engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)”.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
3) Remove the frame covers and frame cover bodies.
Refer to “Exterior Parts Removal and Installation in
Section 9D (Page 9D-4)”.
4) Drain engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-12)”.
5) Disconnect the battery (–) lead wire (1).
6) Remove the air cleaner box (2). Refer to “Air Cleaner
Box Removal and Installation (Page 1D-6)”.
7) Remove the radiator assembly (3). Refer to
“Radiator / Cooling Fan Motor Removal and
Installation in Section 1F (Page 1F-5)”.
8) Remove the rear frame body cover (4) and radiator
inlet hose (5).
9) Remove the muffler (6), exhaust assembly (7) and
front exhaust pipe (8). Refer to “Exhaust Pipe /
Muffler Removal and Installation in Section 1K
(Page 1K-3)”.
10) Remove the throttle body assembly (9). Refer to
“Throttle Body Removal and Installation (Page 1D-
10)”.
11) Disconnect the ECT sensor coupler (10).
1
I944H1140286-01
2
I944H1140287-01
3
I944H1140288-01
4
5
I944H1140289-01
6
8
7
I944H1140290-01
9
I944H1140291-01
10
I944H1140292-01
To Next Page
Loading...
