Suzuki SFV650 - Dimmer Switch Inspection; Specifications; Service Data; Special Tool

Lighting Systems: 9B-15
Dimmer Switch Inspection
B944H19206023
Inspect the dimmer switch in the following procedures:
1) Remove the left frame body cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the dimmer switch for continuity with a tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebars Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the dimmer switch inspection, reinstall
the removed parts.
Specifications
Service Data
B944H19207001
Wattage
Unit: W
Tightening Torque Specifications
B944H19207002
NOTE
The specified tightening torque is described in the following.
“Rear Lighting System Construction (Page 9B-6)”
“Rear Combination Light Components (Page 9B-7)”
“Front Turn Signal Light Construction (Page 9B-10)”
“Turn Signal Light Components (Page 9B-11)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
1
I944H1920036-03
Position
Color
WY O
HI
LO
I944H1920043-01
Item
Specification
E-03, 28, 33 E-02, 19, 24
Headlight
HI 60 ←
LO 55 ←
Position/Parking light 5 ←
Brake light/Taillight 21/5 ←
Turn signal light 21 x 4 10 x 4
License plate light 5 ←
Speedometer light LCD ←
Tachometer light LED ←
Turn signal indicator light LED ←
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Rear combination light mounting bolt 1.8 0.18 1.5 )(Page 9B-8)
Rear turn signal light mounting nut
1.3 0.13 1.0
)(Page 9B-8) /
)(Page 9B-12)
Front turn signal light mounting nut 1.3 0.13 1.0 )(Page 9B-11)