Suzuki SFV650 - Swingarm Related Parts Inspection

2C-9 Rear Suspension:
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Install the washer and swingarm pivot nut (1).
• Tighten the swingarm pivot nut to the specified torque.
Tightening torque
Swingarm pivot nut (a): 100 N·m (10.0 kgf-m, 72.5
lbf-ft)
• Tighten the rear shock absorber upper mounting nut
(2), rear shock absorber lower mounting bolt (3) and
cushion rod upper mounting nut (4) to the specified
torque.
Tightening torque
Rear shock absorber upper mounting nut (b): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
Rear shock absorber lower mounting bolt (c): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
Cushion rod upper mounting nut (d): 78 N·m (7.8
kgf-m, 56.5 lbf-ft)
Swingarm Related Parts Inspection
B944H12306012
Refer to “Swingarm Removal and Installation (Page 2C-
8)”.
Spacers
1) Remove the spacers (1) from the swingarm.
2) Inspect the spacers for wear and damage. If any
defects are found, replace the spacers with new
ones.
Chain Buffer
Inspect the chain buffer for wear and damage. If any
defect is found, replace the chain buffer with a new one.
Swingarm Bearing and Cushion Rod Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to “Swingarm Bearing Removal and
Installation (Page 2C-10)”.
(a)
1
I944H1230032-01
(b)
2
I944H1230033-02
(d)
4
(c)
3
I944H1230034-02
1
1
I944H1230035-01
I944H1230036-01
I944H1230037-01