Engine General Information and Diagnosis: 1A-84
DTC “C31” (P0705): GP Switch Circuit Malfunction
B944H11104020
Detected Condition and Possible Cause
Wiring Diagram
ECM coupler (Harness side)
Troubleshooting
CAUTION
!
When using the multi-circuit tester, do not strongly touch the terminal of the ECM coupler with a
needle pointed tester probe to prevent terminal damage.
NOTE
After repairing the trouble, clear the DTC using SDS tool. Refer to “Use of SDS Diagnosis Reset
Procedures (Page 1A-15)”.
Detected Condition Possible Cause
Gear position signal voltage should be higher than the
following.
Gear position sensor voltage ≥ 0.2 V
If lower than the above value for 3 seconds and more.
• GP switch circuit open or short.
• GP switch malfunction.
• ECM malfunction.
N
1
5
4
2
3
ECM
6
B/W
P
Bl
Bl
P
B/W
GP switch
Side-stand relay
Neutral indicator light
Side-stand switch
Ignition
switch
To the engine stop switch
Neutral26
GP
1
E1
13
I944H1110068-02
1234567891011121314151617
18
18 19 20 21 22 23 26 2724 25 28 29 30 31 32 33 34
35
36
37 38 39 40 41 42 43
44 45 46 47 48 49 50 51 52
I944H1110069-01