Charging System: 1J-13
Battery Visual Inspection
B944H11A06010
Inspect the battery in the following procedures:
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-4)”.
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the seat. Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-4)”.
Specifications
Service Data
B944H11A07001
Electrical
Unit: mm (in)
CAUTION
!
Never use anything except the specified battery.
Tightening Torque Specifications
B944H11A07002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
Item Specification Note
Generator coil resistance 0.3 – 1.2 Ω
Generator maximum output 375 W at 5 000 r/min
Generator no-load voltage
(When engine is cold)
60 V (AC) and more at 5 000 r/min
Regulated voltage 14.0 – 15.5 V at 5 000 r/min
Battery
Type designation YT12A-BS
Capacity 12 V 36.0 kC (10 Ah)/10 HR
Standard electrolyte S.G. 1.320 at 20 °C (68 °F)
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Generator stator set bolt 11 1.1 8.0 )(Page 1J-6)
CKP sensor mounting bolt 6.5 0.65 4.7 )(Page 1J-6)
Generator rotor bolt 140 14.0 101.5 )(Page 1J-6)
Speed sensor bolt 4.5 0.45 3.0 )(Page 1J-7)
Clutch release arm bolt 9 0.9 6.5 )(Page 1J-8)
To Next Page
Loading...
