Suzuki SFV650 - Rear Turn Signal Light Removal and Installation

9B-12 Lighting Systems:
Rear Turn Signal Light Removal and Installation
B944H19206015
Removal
1) Remove the pillion rider handles (1) and rear frame
cover (2). Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-4)”.
2) Disconnect the clamp (3) and rear turn signal light
coupler (4).
Right side
Left side
3) Remove the rear fender cover (5) by removing the
screw (6).
4) Remove the rear turn signal light (7) by removing the
nut (8).
Installation
Install the rear turn signal light in the reverse order of
removal. Pay attention to the following point:
• Tighten the rear turn signal light mounting nut (1) to
the specified torque.
Tightening torque
Rear turn signal light mounting nut (a): 1.3 N·m (
0.13 kgf-m, 1.0 lbf-ft)
• Rout the turn signal light lead wire. Refer to “Wiring
Harness Routing Diagram in Section 9A (Page 9A-5)”.
1
2
I944H1920028-01
3
4
I944H1920029-02
3
4
I944H1920030-02
“A”: Hooked point
5
6
“A”
“A”
I944H1920031-02
7
8
I944H1920032-02
(a)
1
I944H1920033-01