Suzuki SFV650 - Page 503

Clutch: 5C-10
6) Install the thrust washer (9).
7) Install the clutch sleeve hub (10) and new lock
washer (11).
NOTE
The removed lock washer (11) must be
replaced with a new one.
8) Install the clutch sleeve hub nut (12).
NOTE
The chamfer side of clutch sleeve hub nut
(12) faces outward.
9) Hold the clutch sleeve hub with the special tool and
tighten the clutch sleeve hub nut (13) to the specified
torque.
Special tool
(A): 09920–53740 (Clutch sleeve hub
holder)
Tightening torque
Clutch sleeve hub nut (a): 50 N·m (5.0 kgf-m,
36.0 lbf-ft)
10) Bend the lock washer to lock nut securely.
11) Install the clutch push rod (14) into the countershaft.
12) Install the clutch push piece (15), the bearing (16)
and thrust washer (17) to the countershaft.
NOTE
Thrust washer is located between the
pressure plate and bearing (16).
9
I944H1530035-02
11
10
12
I944H1530036-02
(a)
13
(A)
I944H1530037-02
I944H1530038-01
15
16
17
14
I944H1530040-02