Suzuki SFV650 - Page 504

5C-11 Clutch:
13) Install the spring washer seat (18) and spring washer
(19) onto the clutch sleeve hub correctly.
14) Apply engine oil to the clutch drive plates and driven
plates.
15) Insert the clutch drive plates and driven plates one
by one into the clutch sleeve hub in the prescribed
order.
NOTE
Two kinds of the drive plate (No. 1 and No. 2)
are equipped in the clutch system, they can
be distinguished by the inside diameter “B”.
16) Install the clutch pressure plate (23) and clutch
springs.
17) Tighten the clutch spring set bolts to the specified
torque.
NOTE
Tighten the clutch spring set bolts diagonally.
Tightening torque
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-
ft)
18) Loosen the lock nut (24) and turn in the release
screw (25) to feel resistance.
19) From that position, turn out the release screw (25) 1
turn and tighten the lock nut (24) securely by holding
the release screw (25).
20. No. 2 drive plate 22. Driven plate
21. No. 1 drive plate “A”: Direction of outside
18
19
I944H1530041-03
I944H1530070-01
22
20
21
“A”
I944H1530043-02
Drive plate I.D. “B”
No. 1 (21) 116 mm (4.5 in)
No. 2 (20) 122.5 mm (4.82 in)
“B” “B”
20
21
I944H1530044-02
23
I944H1530065-02
24
25
I944H1530045-02