Suzuki SFV650 - Page 425

Drive Chain / Drive Train / Drive Shaft: 3A-3
13) Remove the washer (15) and engine sprocket (16).
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Put the drive chain on the engine sprocket.
• Install the engine sprocket (1) and washer (2).
• Install the lock washer (3).
CAUTION
!
The removed lock washer must be replaced
with a new one.
• Apply Thread lock super to the driveshaft.
: Thread lock cement 99000–32030 (Thread
Lock Cement Super 1303 or equivalent)
• Tighten the engine sprocket nut (4) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 145 N·m (14.5 kgf-m,
105.0 lbf-ft)
• Bend the lock washer (3).
• Tighten the speed sensor rotor bolt (5) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 25 N·m (2.5 kgf-m,
18.0 lbf-ft)
• Install the dowel pins (6).
• Install the engine sprocket inner cover (7).
• Tighten the speed sensor mounting bolt (8) to the
special torque.
Tightening torque
Speed sensor mounting bolt (c): 5 N·m (0.5 kgf-
m, 3.5 lbf-ft)
15
16
I944H1310006-02
3
1
2
I944H1310007-02
(a)
4
I944H1310008-02
3
I944H1310031-01
6
(b)
5
I944H1310009-05
7
(c)
8
I944H1310010-03