Engine General Information and Diagnosis: 1A-64
P1651-L (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the seat. Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-4)”.
3) Check the TO sensor coupler (1) for loose or poor
contacts.
If OK, then check the TO sensor lead wire continuity.
4) Disconnect the TO sensor coupler and ECM coupler.
Refer to “ECM Removal and Installation in Section 1C
(Page 1C-1)”.
5) Check there is no continuity between the R wire “A” and
ground.
Also the R wire “A” and another wire.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Is there no continuity?
Go to Step 2. Short circuit in the R
wire.
1
I944H1110051-01
(A)
“A”
I944H1110175-01
To Next Page
Loading...
