Engine Mechanical: 1D-14
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-m,
2.5 lbf-ft)
NOTE
Make sure the throttle valve open or close
smoothly. If the TP sensor adjustment is
necessary, refer to “TP Sensor Adjustment in
Section 1C (Page 1C-2)”.
• Apply a small quantity thin coat of the engine oil to the
new cushion seal (3) and O-ring (4).
CAUTION
!
Replace the cushion seal and O-ring with the
new ones.
• Wipe off the mounting surface on the delivery pipe (6)
where the fuel injector (5) will be seated with a clean
rag.
• Install the fuel injector (5) by pushing it straight to the
delivery pipe (6).
CAUTION
!
Never turn the injector while pushing it.
NOTE
Align the coupler “E” of the injector with
boss “F” of the delivery pipe.
• Install the fuel delivery pipe assemblies (7) to the
throttle body assembly.
CAUTION
!
• When installing the fuel delivery pipes to
the throttle body, pay attention to the
difference of the fuel delivery pips.
• Never turn the fuel injectors while
installing them.
“D”
“C”
2
I944H1140279-01
I944H1140280-01
3
4
I944H1140281-01
“G”: Front side “H”: Rear side
“F”
6
“E”
5
I944H1140282-01
7
“G”
“H”
I944H1140283-01
To Next Page
Loading...
