Engine Mechanical: 1D-38
• Before replacing the camshafts on cylinder head,
apply molybdenum oil solution to their journals and
cam faces.
• Apply molybdenum oil solution to the camshaft journal
holders.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
NOTE
Before installing the camshaft, check that the
tappets are installed correctly.
• Pull the cam chain lightly.
• The No. 2 intake camshaft sprocket has an arrow
mark “1R” “C”. Install the intake camshaft so that the
arrow “C” is aligned with the mating surface of the
cylinder head.
• Engage the cam chain with the intake camshaft
sprocket.
NOTE
Before installing the camshaft, check that the
tappets are installed correctly.
• The other arrow marked “2” “D” should now be
pointing straight up. Starting from the roller pin that is
directly above the arrow marked “2” “D”, count out 16
roller pins (from the intake camshaft side going
towards the exhaust camshaft side).
• Engage the 16th roller pin “E” on the cam chain with
the marked “3” on the exhaust sprocket.
NOTE
The cam chain should now be on all three
sprockets. Be careful not to move the
crankshaft until the camshaft journal holders
and cam chain tension adjuster are secured.
I944H1140191-01
“C”
I944H1140192-01
“D”
“E”
I944H1140193-01
To Next Page
Loading...
