Suzuki SFV650 - Page 251

Engine Mechanical: 1D-62
Gear Position Switch
1) Remove the driveshaft oil seal retainer (1) by
removing its bolts (2).
2) Remove the gear position switch (3) by removing its
bolts (4).
3) Remove the O-ring (5).
Crankcase
1) Remove the oil plate (1) by removing the its bolts (2).
2) Remove the crankcase bolts (M6) (3).
3) Remove the crankcase bolts (M8) (4).
NOTE
Loosen the crankcase bolts diagonally and
smaller sizes first.
4) Separate the crankcase into two parts, right and left
with the special tool.
NOTE
• Fit the crankcase separating tool, so that
the tool arms are in parallel with the side of
crankcase.
• The crankshaft and transmission
components should remain in the left
crankcase half.
Special tool
(A): 09920–13120 (Crankcase separating
tool)
1
2
2
I944H1140024-02
3
5
4
I944H1140025-02
1
2
I944H1140026-02
3
4
4
3
3
I944H1140027-02
4
4
I944H1140028-02
(A)
I944H1140029-02