Engine Mechanical: 1D-64
Oil Gallery Jet (for Cylinder)
Remove the oil gallery jets (1) (for cylinder) from left and
right crankcase halves.
Oil Gallery Jet (for Transmission)
1) Remove the clutch push rod oil seal (1).
2) Remove the oil gallery plug (M8) (2).
3) Remove the oil gallery plug (M6) (3) if necessary.
4) Remove the oil gallery jet (for transmission) (4) with
a suitable bar (5).
Crankshaft Journal Bearing
1) Set the special tool as shown to remove the
crankshaft journal bearings (1) with the special tool.
NOTE
Remove the crankshaft journal bearings in
only one direction, from inside to outside of
each crankcase half.
Special tool
(A): 09913–60221 (Journal bearing installer
and holder)
2) Gradually press out the journal bearings with the
special tool by using the hydraulic-press.
1
I944H1140037-02
3
1
2
I944H1140038-01
4
5
I944H1140039-02
1. Journal bearing 3. hydraulic press
2. Crankcase
(A)
1
I944H1140040-01
I944H1140041-01
(A)
1
2
3
I944H1140042-01
To Next Page
Loading...
