Suzuki SFV650 - Page 349

Starting System: 1I-11
6) Remove the one way clutch (7) from the guide (8).
Installation
Install the starter clutch in the reverse order of removal.
Pay attention to the following points:
• Apply engine oil to the one way clutch (1).
• When inserting the one way clutch (1) into the guide
(2), fit the flange “A” in the step of the guide (2).
NOTE
Be sure to seat the flange “A” of the one way
clutch (1) to the guide (2).
• Install the guide (3) to the generator rotor with the
arrow mark “B” faced upward.
• Apply THREAD LOCK to the bolts (4), and then
tighten them to the specified torque with the special
tool.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Special tool
(A): 09930–44530 (Rotor holder)
Tightening torque
Starter clutch bolt (a): 25 N·m (2.5 kgf-m, 18.0 lbf-
ft)
• Apply engine oil to the starter idle gear shaft hole.
7
8
I944H1190027-02
1
2
“A”
I944H1190028-01
“A”
I944H1190029-01
“B”
3
I944H1190030-03
(A)
(a)
4
(a)
4
I944H1190031-03
I944H1190032-02