EasyManua.ls Logo

Suzuki SFV650 - Page 37

Suzuki SFV650
573 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance and Lubrication: 0B-11
6) Turn off the engine and wait about three minutes,
then check the oil level through the inspection
window (3). If the oil level is below the “L” mark, add
oil to the “F” mark. If the level is above the “F” mark,
drain the oil until the level reaches the “F” mark.
Oil Level Inspection
1) Keep the motorcycle upright.
2) Start up the engine and allow it to run for few minutes
at idle speed.
3) Turn off the engine and wait about three minutes,
then check the oil level through the inspection
window (1). If the level is below mark “L”, add oil to
“F” mark. If the level is above mark “F”, drain oil to
“F” mark.
Oil Filter Replacement
1) Drain engine oil as described in the engine oil
replacement procedure.
2) Remove the oil filter (1) using the special tool.
Special tool
(A): 09915–40620 (Oil filter wrench)
3) Apply engine oil lightly to the O-ring of new oil filter,
before installation.
CAUTION
!
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturers oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
4) Install a new oil filter. Turn it by hand until you feel
that the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
(A): 09915–40620 (Oil filter wrench)
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lbf-ft)
5) Add new engine oil and check the oil level is as
described in the engine oil replacement procedure.
Necessary amount of engine oil
Oil change: 2 400 ml (2.5/2.1 US/lmp qt)
Oil and filter change: 2 750 ml (2.9/2.4 US/lmp qt)
Engine overhaul: 3 000 ml (3.2/2.6 US/lmp qt)
3
I944H1020025-01
1
I944H1020026-01
1
(A)
I944H1020027-01
(A)
(a)
1
I718H1020026-01

Table of Contents

Related product manuals