Suzuki SFV650 - Page 372

1K-6 Exhaust System:
• Install the new exhaust connectors (3).
NOTE
When installing new exhaust connectors,
remove the old sealer from the exhaust pipe
and exhaust.
Apply the exhaust gas sealer to both the
inside and outside of the new exhaust
connector.
: Muffler seal (MUFFLER SEAL LOCTITE
5920 (commercially available) or equivalent)
• Install the new gasket (4).
• Tighten the rear exhaust pipe bolts (5) to the specified
torque.
Tightening torque
Exhaust pipe bolt (c): 23 N·m (2.3 kgf-m, 16.5 lbf-
ft)
• Install the new gasket (6).
• Tighten the exhaust mounting bolts (7) and front
exhaust pipe bolts (8) to the specified torque.
Tightening torque
Exhaust pipe bolt (c): 23 N·m (2.3 kgf-m, 16.5 lbf-
ft)
Exhaust mounting bolt (d): 23 N·m (2.3 kgf-m,
16.5 lbf-ft)
• Tighten the exhaust cover bolts (9) and exhaust pipe
connecting bolts (10) to the specified torque.
Tightening torque
Exhaust cover bolt (e): 5.5 N·m (0.55 kgf-m, 4.0
lbf-ft)
Exhaust pipe connecting bolt (f): 23 N·m (2.3 kgf-
m, 16.5 lbf-ft)
3
3
I944H11B0020-03
4
(c)
5
I944H11B0021-03
6
I944H11B0022-03
(d)
7
I944H11B0024-03
(d)
7
(c)
8
I944H11B0023-03
(e)
9
I944H11B0025-03