Maintenance and Lubrication: 0B-21
Compression Pressure Check
B944H10206024
Refer to “Compression Pressure Check in Section 1D
(Page 1D-3)”.
Oil Pressure Check
B944H10206025
Refer to “Oil Pressure Check in Section 1E (Page 1E-
5)”.
SDS Check
B944H10206026
Refer to “SDS Check in Section 1A (Page 1A-18)”.
Specifications
Tightening Torque Specifications
B944H10207001
NOTE
The specified tightening torque is described in the following.
“Chassis Bolt and Nut Inspection (Page 0B-19)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
21 Rear shock absorber mounting bolt (Lower) 50 N⋅m (5.0
kgf-m, 36.0 lbf-ft)
22 Cushion lever mounting nut 78 N⋅m (7.8 kgf-m, 56.5 lbf-ft)
23 Cushion rod mounting nut 78 N⋅m (7.8 kgf-m, 56.5 lbf-ft)
24 Front fork upper clamp bolt 23 N⋅m (2.3 kgf-m, 16.5 lbf-ft)
25 Front fork lower clamp bolt 23 N⋅m (2.3 kgf-m, 16.5 lbf-ft)
(m)
23
(m)
22
(l)
21
I944H1020062-02
(b)
25
(b)
24
I944H1020063-01
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Exhaust pipe bolt 23 2.3 16.5 )(Page 0B-4)
Exhaust mounting bolt 23 2.3 16.5 )(Page 0B-4)
Exhaust pipe connecting bolt 23 2.3 16.5 )(Page 0B-4)
Muffler connecting bolt 23 2.3 16.5 )(Page 0B-4)
Muffler mounting nut 25 2.5 18.0 )(Page 0B-4)
Oil drain plug 21 2.1 15.0 )(Page 0B-10)
Oil filter 20 2.0 14.5 )(Page 0B-11)
Engine coolant drain bolt 13 1.3 9.5 )(Page 0B-13)
Rear axle nut 100 10.0 72.5 )(Page 0B-16)
Rear brake master cylinder rod lock-nut 18 1.8 13.0 )(Page 0B-17)
To Next Page
Loading...
