5B-4 Manual Transmission:
Gearshift cam / Gearshift fork
• Install the gearshift forks into the gearshifting grooves
in the correct position and direction.
• Install the gearshift cam (4) so that the pins “A” face
upward (right crankcase side).
• Install the gearshift fork shaft (5).
NOTE
• After the gearshift fork shaft and gearshift
forks have been fitted, make sure that the
gears engage normally.
• Set the transmission gears to the neutral
position.
• Install the crankshaft (6).
NOTE
• Be sure to set the crankshaft in the proper
direction.
• Of the two conrods, the one with the
embossed letter marked should be
brought to the rear cylinder.
• Install the right crankcase. Refer to “Engine Bottom
Side Assembly in Section 1D (Page 1D-65)”.
• Install the engine sprocket spacer (7).
NOTE
The grooved “C” side of the engine sprocket
spacer (7) must face crankcase side.
• Assemble the engine. Refer to “Engine Bottom Side
Assembly in Section 1D (Page 1D-65)” and “Engine
Top Side Assembly in Section 1D (Page 1D-31)”.
• Remount the engine assembly. Refer to “Engine
Assembly Installation in Section 1D (Page 1D-22)”.
1. Gearshift fork No. 1
2. Gearshift fork No. 2
3. Gearshift fork No. 3
1
2
3
I944H1520006-01
1
2
3
I944H1520007-01
5
5
4
“A”
I944H1520008-01
“B”: Embossed letter
“B”
6
I944H1520009-01
7
“C”
“C”
I944H1520010-01
To Next Page
Loading...
