Suzuki SFV650 - Page 567

Exterior Parts: 9D-6
8) Remove the rear fender cover (9) by removing the
screw (10).
9) Remove the rear fender assembly (11) by removing
the bolts (12).
Installation
Install the pillion rider handle and rear fender in the
reverse order of removal. Pay attention to the following
point:
• Apply thread lock to the rear fender mounting bolts
(1).
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Rout the wiring harness. Refer to “Wiring Harness
Routing Diagram in Section 9A (Page 9A-5)”.
• Apply thread lock to the pillion rider handle mounting
bolts (2).
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Frame Body Cover
Removal
Remove the frame body cover(-s), (1) left and right.
Installation
Install the frame body cover(-s) in the reverse order of
removal.
“A”: Hooked point
“A”
“A”
10
9
I944H1940013-04
12
12
I944H1940014-03
11
I944H1940015-03
“A”: Guide
1
1
I944H1940016-01
2
2
I944H1940017-01
1
“A”
I944H1940019-01