USTER HVI SPECTRUM - Page 12

USTER
®
HVI SPECTRUM Instruction Manual
viii
Figure 4-11: Calibration Screen.................................................4-17
Figure 4-12: Calibrate Flash and Trash Screen ............................4-18
Figure 4-13: Main Menu - Setup ................................................4-21
Figure 4-14: Temperature and Humidity Calibration.....................4-22
Figure 4-15: UV/CALIBRATION Screen..........................................4-23
Chapter 5
Figure 5-1: System Check Button..................................................5-1
Figure 5-2: Main Menu - SETUP....................................................5-2
Figure 5-3: System Check Test Selection Menu...............................5-3
Figure 5-4: System Check Micronaire Screen.................................5-4
Figure 5-5: System Check Length/Strength Screen..........................5-6
Figure 5-6: System Check Color/Trash Screen...............................5-8
Chapter 6
Figure 6-1: Main Menu - Setup ....................................................6-1
Figure 6-2: System
Configuration – Test Setup Tab .........................6-2
Figure 6-3: Main Menu - Setup ....................................................6-6
Figure 6-4: Lot Limits Screen ........................................................6-7
Figure 6-5: Error Message - Lot Limit Name Already Exists ..............6-8
Figure 6-6: Lot Limits Screen – 0 Property......................................6-8
Figure 6-7: New Lot Limit Added .................................................6-9
Figure 6-8: Lot Limits Screen – Edit ...............................................6-9
Figure 6-9: Lot limit updated......................................................6-10
Figure 6-10: Lot Limits Screen - Delete.........................................6-11
Figure 6-11: “DELETING LOT LIMIT 1. ARE YOU SURE?” .......................6-11
Figure 6-13: Measurement Selection Tab ....................................6-12
Figure 6-14: General Setup Tab ................................................6-13
Figure 6-15: Screen Temperature and RH Tab .............................6-14
Figure 6-17: Reset Tolerances Tab .............................................6-16
Figure 6-18: USTER® SCI Regression Coefficients Tab..................6-18
Chapter 7
Figure 7-1: Main Menu ..............................................................7-3
Figure 7-2: Testing Button ...........................................................7-4
Figure 7-3: Testing Mode Selection Screen....................................7-4
Figure 7-4: Operator ID Entry Dialog Box .....................................7-5
Figure 7-5: Testing Screen...........................................................7-6
Figure 7-6: M
EASUREMENT OUT OF LOT LIMITS DIALOG BOX .................7-11
Figure 7-7: Bales Out of Tolerance Dialog Box ............................7-12
Chapter 8
Figure 8-1: Reports Button ...........................................................8-1