Testing the Rear 12 Volt Switch
1. Park the machine on a level surface, lower any attachments to the ground,
engage the parking brake and remove the key from the ignition.
2. Switch the main circuit breaker to the O
FF position, to de-energize the electrical
system.
3. Remove the control panel from the right seat box; refer to Removing and
Installing the Control Panel, page 7–19.
4. Identify the rear 12 volt switch light located inside the right seat box and
disconnect the wire harness connector from the switch, remove the switch from
the control panel if necessary.
5. Use a multimeter (ohms setting) and the preceding table to determine whether
continuity exists between the terminals for each switch position.
6. Replace the switch if necessary.
7. If the switch tests correctly and a circuit problem still exists, check the wire
harnesses; refer to 9 Appendix A, page 9–1.
8. Install the switch, connect the wire harness, and install the control panel after
testing.
9. Switch the main circuit breaker to the O
N position, to energize the electrical
system.
Rear 12 Volt Momentary Switch
POSITION CLOSED CIRCUITS
G423467
REAR 12V ON 8 + 9 + 2 & 8 + 7 + 4
REAR 12V OFF NONE
The rear 12 volt momentary switch is located on the right seat box. Pushing down on
the left or right side of the momentary switch provides power to the 12 volt 4 pin
socket as long as the switch is held down. Releasing the switch turns off power to the
12 volt 4 pin socket.
4520P Page 6–37 Electrical System: Rear 12 Volt Switch
09.40003Rev 00
To Next Page
Loading...
