Jacking Instructions
CAUTION
Failing to properly support the machine with appropriate jack stands can cause
the machine to move or fall and can result in personal injury.
When changing the attachments, tires, or performing other services, do the
following steps:
• Use correct blocks, hoists, and jacks to raise and support the machine.
• Park the machine on a solid level surface, such as a concrete floor.
• Before you lift the machine, remove all the attachments from the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
Raising the Front of the Machine
1. Remove all attachments from the machine.
2. Ensure that the front hitch arms
are parallel to the ground as shown.
Figure 1
G415644
Hitch Arms
3. Park the machine on a level surface, engage the parking brake, and remove the
key from the ignition.
4. Block the rear wheels using wheel chocks to prevent the machine from rolling.
General Safety Instructions: Jacking Instructions Page 1–6 4520P
09.40003Rev 00
To Next Page
Loading...
