Installing the High / Low Shift Cable (continued)
4. Install the rear of the cable onto the frame ensure that a star washer is under
each jam nut on each side of the mounting bracket. Secure the jam nuts in place.
5. Ensure that the high-low shifter is in the low range position install the clevis end
onto the shift lever, secure the clevis pin in place.
6. With the transaxle set in the low gear position, secure the clevis end onto the rear
transaxle shift lever. Ensure that there is no resistance felt on the clevis pin when
installing it through the clevis. If resistance is felt adjust the clevis end by turning
the shift cable until the pin may be inserted with no resistance. Secure the clevis
pin in place.
7. Place the high-low shifter in the high range position. Rotate the rear transaxle
until the high-low shifter can move freely between low and high settings on the
transaxle with no resistance.
Removing the Rear Weight Mount
Figure 108
G443928
Lower mounting bolts
Upper mounting bolts
1. Remove any attachments from the machine, park the machine on a level surface,
engage the parking brake, remove the key from the ignition, and switch the circuit
breaker to the O
FF position.
2. Remove all weights from the rear weight mount.
3. Remove the left rear taillight.
4. Remove the rear transaxle skid plate.
5. Remove the four lower rear weight mount, mounting bolts
.
6. Remove the six upper rear weight mount, mounting bolts
.
7. Remove the rear weight mount from the machine.
Chassis: Service and Repairs Page 7–44 4520P
09.40003Rev 00
To Next Page
