Testing the PTO Electric Clutch (continued)
5. As an additional test, apply 12 volts to the terminals of the PTO electric clutch.
The clutch should engage. If the clutch does not engage when voltage is applied,
replace the PTO electric clutch.
6. If the clutch tests correctly and a circuit problem still exists, check the wire
harnesses; refer to 9 Appendix A, page 9–1.
7. Connect the clutch electrical connector to the main harness.
4520P Page 6–41 Electrical System: PTO Electric Clutch
09.40003Rev 00
To Next Page
Loading...
