Removing and Installing the Hydraulic Cooler Inner
Cover (continued)
9. Remove the hydraulic cooler inner cover .
10. To install the hydraulic cooler inner cover, position the cover against the seat box
frame and hydraulic cooler top cover aligning the mounting holes.
11. Loosely install the mounting bolts.
12. Install the fuse panel mounting bolts.
13. Tighten the mounting bolts.
14. Connect the USB receptacle, rear 12–volt switch, and rear 12–volt momentary
switch (if equipped) electrical connectors to the main wiring harness.
15. Install the hydraulic cooler top cover.
16. Install the control panel.
17. Install the SDLA pivot cover.
18. Switch the main circuit breaker to the O
N position, to energize the electrical
system.
Removing and Installing the SDLA Pivot Cover
Figure 87
G429942
Flange bolt
SDLA pivot cover
1. Park the machine on a level surface, lower any attachments to the ground,
engage the parking brake, and remove the key from the ignition.
Chassis: Service and Repairs Page 7–22 4520P
09.40003Rev 00
To Next Page
