Removing and Installing the Steering Valve Cover
Figure 98
G435107
Steering valve cover
Mounting bolt
1. Park the machine on a level surface, lower any attachments to the ground,
engage the parking brake, and remove the key from the ignition.
2. Switch the main circuit breaker to the O
FF position, to de-energize the electrical
system.
3. Remove the steering valve cover
, by removing the mounting bolt .
4. Remove the steering valve cover from the machine.
5. To install the steering valve cover, insert the top flange of the cover in the upper
cutout in the dash aligning the mounting holes.
6. Install the mounting bolt.
7. Switch the main circuit breaker to the O
N position, to energize the electrical
system.
4520P Page 7–33 Chassis: Service and Repairs
09.40003Rev 00
To Next Page
