Removing and Installing the Seat (continued)
14. Switch the main circuit breaker to the ON position, to energize the electrical
system.
15. Check the operation of the interlock switches; refer to Checking the Operation of
the Interlock Switches, page 6–6.
Removing and Installing the Seat Mount
Figure 96
G430871
Seat mount
Acorn nut
Washer
Note: The seat mount can be removed with or without the seat installed.
1. Park the machine on a level surface, lower any attachments to the ground,
engage the parking brake, and remove the key from the ignition.
2. Switch the main circuit breaker to the O
FF position, to de-energize the electrical
system.
3. Tilt the seat forward and secure it in place with the seat prop.
4. Remove the seat as necessary; refer to Removing and Installing the Seat, page
7–30.
5. If the seat is not being removed, disconnect the electrical connector(s) from the
main wiring harness.
6. Remove the two acorn nuts
and washers .
7. Lift the seat mount from the machine.
8. To install the seat mount, position the seat mount on the machine with the
mounting bolts resting in the hinge bracket.
9. Install the washers and acorn nuts on the mounting bolts.
10. Install the seat as required.
11. Connect the seat electrical connector(s).
12. Return the seat to the operating position.
13. Switch the main circuit breaker to the O
N position, to energize the electrical
system.
4520P Page 7–31 Chassis: Service and Repairs
09.40003Rev 00
To Next Page
