C H A P T E R 1 6 - C H A N G E L O G
AT5600 User Manual 98-119 issue 14 Page 429
R CTY Increased the current ranges for DCR range combinations to reduce
the decrease the probability of 0002 error codes.
R CTY Improved the low impedance detection on high DC resistance range
combinations.
R CTY Resistance ranges and signal levels have been adjusted to give
improved accuracy, particularly around 100 ohms.
TRL L2 Improved the trimming algorithm for TRL and L2 to reduce the effect of
limits on the measured value when in auto mode.
VOC Improved noise rejection for VOC tests by utilizing harmonic analysis.
(ID 9515)
VOCX WATX MAGX Improved the execution sequence for MAGX, WATX and
VOCX to dramatically increase execution speed.
VOCX WATX MAGX Added class D current limiting to the energization process
for MAGX, WATX and VOCX tests when used with AT output + Transformer
VOCX WATX MAGX External magnetizing tests no longer disable ESE even
when the signal level or frequency changes. ESE is enabled for all sequential AC IF
tests.
To Next Page
Loading...
Need help?
General
